Everything below concerns pentapeptide. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2026-03-20. Where a claim depends on a specific study, the study is described rather than over-claimed.
Purity is normally reported as a percentage of total peak area, a figure that does not account for water content, residual solvents, or counterions. Trifluoroacetate and acetate are the most frequent counterions in lyophilized peptides, and they shift the true peptide content away from the mass of the powder. A separate quantitative assay is therefore needed to state content accurately. Certificates of analysis often omit these details, which makes batch-to-batch comparison difficult and limits conclusions drawn when results from different suppliers are compared.
Lyophilized material is generally held at minus twenty degrees Celsius or lower, protected from moisture and light. Repeated excursions to room temperature cause condensation inside the vial and gradual moisture uptake, both of which shorten shelf life. Containers should be allowed to equilibrate before opening so that water does not condense on the solid. Dividing a batch into single-use aliquots reduces freeze-thaw cycling. Solid peptide handled this way is usually considered stable for months to years, while the same material in solution degrades on a much shorter timescale.
Research quantities of ipamorelin are typically distributed as a white to off-white lyophilized powder. The solid dissolves readily in water and in aqueous buffers, and stock solutions are commonly prepared in sterile water or a mildly acidic diluent. Adsorption to plastic and glass surfaces can reduce the concentration of very dilute solutions, so containers and transfer steps deserve attention when accurate concentrations matter. Reconstituted material is generally used promptly rather than held for extended periods.
Storage recommendations for the dry solid center on low temperature and low moisture, most often -20 °C in a sealed, desiccated container protected from light. Solutions are less stable than the powder and are usually kept cold and used within a short window. Freeze-thaw cycling is a recognized source of loss, and aliquoting before freezing is a standard precaution. These practices derive from general peptide handling principles rather than from a single published stability trial, so exact shelf lives should be treated as approximate.
| Property | Value | Notes |
|---|---|---|
| Purity method | Reversed-phase HPLC | C18 column, UV detection at 214 nm |
| Identity method | Mass spectrometry | Electrospray or MALDI-TOF |
| Solubility | Soluble in water and DMSO | Dissolution may require brief mixing |
| Storage temperature | -20 °C or lower | Desiccated and protected from light |
| Counterion form | Trifluoroacetate or acetate | Affects measured peptide content |
The compound was developed at Novo Nordisk during the 1990s as part of a programme seeking secretagogues with improved selectivity. It was described in the peer-reviewed literature in 1998 alongside related pentapeptides from the same series. Investigators advanced it because it raised growth hormone output in animal models while leaving other pituitary hormones comparatively unaffected. The development code NNC 26-0161 appears in earlier reports, and ipamorelin later became the common designation in published work.
Selectivity is the property most often attached to this peptide. Published animal and early human studies record increases in growth hormone release after administration, with adrenocorticotropic hormone and cortisol responses remaining small by comparison. Effects on appetite-related pathways also appear weaker than those reported for several earlier secretagogues. Reviews that compare members of the growth hormone secretagogue family cite these findings frequently, though the receptor-level explanation for the selectivity continues to be debated rather than settled.
Ipamorelin is a synthetic pentapeptide classified as a growth hormone secretagogue. Its sequence, Aib-His-D-2-Nal-D-Phe-Lys-NH2, combines three non-proteinogenic residues with a C-terminal amide. The N-terminal aminoisobutyric acid unit and the two aromatic D-amino acids distinguish it from peptides assembled only from standard L-amino acids. Its formula is C38H49N9O5, corresponding to an average mass near 711.9 Da. At neutral pH the molecule carries a net positive charge, a property that shapes its behaviour in chromatographic and electrophoretic systems.
Most published work on ipamorelin comes from rodent studies and small early-phase human trials. Subcutaneous and intravenous routes have been used, while oral delivery is limited by poor absorption and rapid breakdown in the gut. The reported plasma half-life is short, on the order of two hours, and varies with species and assay method. Whether chronic use produces meaningful clinical benefit remains unresolved, and long-term safety data in humans are sparse. No major regulatory agency has approved the compound as a therapeutic drug.
Ipamorelin is a synthetic pentapeptide that belongs to the growth hormone secretagogue family. Its sequence is Aib-His-D-2-Nal-D-Phe-Lys-NH2, incorporating two non-natural residues that resist enzymatic breakdown. Researchers at Novo Nordisk described the compound in the 1990s while searching for agents that release growth hormone with fewer side effects than earlier secretagogues. The molecule acts as an agonist at the ghrelin receptor, also called GHS-R1a, which is expressed in the pituitary and in several peripheral tissues.
Selectivity distinguishes ipamorelin from first-generation secretagogues such as GHRP-6. At doses that reliably raise growth hormone, it shows little stimulation of adrenocorticotropic hormone or cortisol release in animal models, and it does not markedly raise prolactin or appetite. Binding at GHS-R1a on pituitary somatotrophs triggers calcium influx and pulsatile growth hormone secretion. Because the compound mimics the natural ghrelin signal, the release pattern tends to follow the body's own rhythm rather than producing a sustained elevation.
Compared with earlier growth hormone secretagogues such as GHRP-6 and hexarelin, ipamorelin has been reported to produce less stimulation of adrenocorticotropic hormone, cortisol, and prolactin in animal and early human studies. This selectivity is usually attributed to differences in receptor subtype interactions and to the tissue distribution of the receptor. Effects on appetite appear weaker than those of ghrelin itself, although the supporting evidence base is small. Whether these differences produce a distinct clinical profile remains an open question, since controlled human trials are limited.
Ipamorelin is a synthetic pentapeptide first described in the 1990s by researchers at Novo Nordisk during a program to develop selective growth hormone secretagogues. Its sequence is Aib-His-D-2-Nal-D-Phe-Lys-NH2, incorporating two non-natural residues, alpha-aminoisobutyric acid and D-2-naphthylalanine. The C-terminus is amidated, and the material is supplied as a white lyophilized powder. The molecular formula is C38H49N9O5 and the monoisotopic mass is approximately 711.85 daltons. The short chain and modified residues give it greater resistance to enzymatic degradation than many larger peptide hormones.
=== Total bilirubin === Total bilirubin = direct bilirubin + indirect bilirubin Elevation of both alanine aminotransferase (ALT) and bilirubin is more indicative of serious liver injury than is elevation in ALT alone, as postulated in Hy's law that elucidates the relation between the lab test results and drug-induced liver injury
=== Solubility === Neutral organic compounds tend to be hydrophobic; that is, they are less soluble in water than in organic solvents. Exceptions include organic compounds that contain ionizable groups as well as low molecular weight alcohols, amines, and carboxylic acids where hydrogen bonding occurs. Otherwise, organic compounds tend to dissolve in organic solvents. Solubility varies widely with the organic solute and with the organic solvent.
Methods commonly used to study protein structure and function include immunohistochemistry, site-directed mutagenesis, X-ray crystallography, nuclear magnetic resonance and mass spectrometry. The activities and structures of proteins may be examined in vitro, in vivo, and in silico. In vitro studies of purified proteins in controlled environments are useful for learning how a protein carries out its function: for example, enzyme kinetics studies explore the chemical mechanism of an enzyme's catalytic activity and its relative affinity for various possible substrate molecules. By contrast, in vivo experiments can provide information about the physiological role of a protein in the context of a cell or even a whole organism, and can often provide more information about protein behavior in different contexts. In silico studies use computational methods to study proteins.
Sources: en.wikipedia.org
Databases are essential for bioinformatics research and applications. Databases exist for many different information types, including DNA and protein sequences, molecular structures, phenotypes and biodiversity. Databases can contain both empirical data (obtained directly from experiments) and predicted data (obtained from analysis of existing data). They may be specific to a particular organism, pathway or molecule of interest. Alternatively, they can incorporate data compiled from multiple other databases. Databases can have different formats, access mechanisms, and be public or private. Some of the most commonly used databases are listed below:
=== Absolute bioavailability === Absolute bioavailability refers to the bioavailability of a drug when administered via an extravascular dosage form (i.e. oral tablet, suppository, subcutaneous, etc.) compared with the bioavailability of the same drug administered intravenously (IV). This is done by comparing the AUC of the non-intravenous dosage form with the AUC for the drug administered intravenously. This fraction is normalized by multiplying by each dosage form's respective dose.
== Other uses == HMS Vesta, a schooner of the Royal Navy IF Vesta, sports club in Uppsala, Sweden established in 1911 SS Vesta (1853–1875), a French iron screw steamer Vesta (name), feminine given name Vesta Rowing Club (founded 1870), a rowing club based in London, England Vesta Battery Corporation (1897–1964), an automobile battery company
Chromatographic methods with fluorescence detection Liquid chromatography with fluorescence detection (LC-FLD) provides a selective, relatively cheap, reproducible method for the qualitative and quantitative analysis of YTX for shellfish and algae samples. This method requires an additional sample preparation step after the analyte extraction procedure has been completed (in this case SPE is preferentially used so common interferences can be removed from the sample). This additional step involves the derivatization of the YTXs with a fluorescent dienophile reagent — dimethoxy-4-methyl-3-oxo-3,4-dihydroquinoxalinyl)ethyl]-1,2,4-triazoline-3,5-dione, which facilitates analyte detection. This additional sample preparation step can make LC-FLD analysis extremely time-consuming and is a major disadvantage of the technique.
Sources: en.wikipedia.org
It is reported as the percentage of total peak area in a reversed-phase chromatogram. That number does not reflect water content, residual solvents, or counterions. The actual peptide content is therefore lower than the stated purity figure suggests.
Trifluoroacetate and acetate are common in lyophilized peptide preparations. They contribute to the mass of the powder without contributing to the peptide itself. This shifts the true content and can affect results in biological assays.
Hydrolysis and oxidation are the primary pathways. Alkaline conditions accelerate hydrolytic cleavage of the chain. Oxidation most often involves susceptible residues, producing products that appear as earlier or later peaks in chromatographic analysis.
Typical guidance is -20 °C in a sealed container with desiccant and protection from light. The powder tolerates handling better than a solution, but repeated warming and cooling is still avoided.